Cervical spine reconstruction after total vertebrectomy using customized three-dimensional-printed implants in dogs.

Abstract

BACKGROUND: Sufficient surgical resection is necessary for effective tumor control, but is usually limited for vertebral tumors, especially in the cervical spine in small animal neurosurgery. OBJECTIVE: To evaluate the primary stability and safety of customized three-dimensional (3D)-printed implants for cervical spine reconstruction after total vertebrectomy. METHODS: Customized guides and implants were designed based on computed tomography (CT) imaging of five beagle cadavers and were 3D-printed. They were used to reconstruct C5 after total vertebrectomy. Postoperative CT images were obtained to evaluate the safety and accuracy of screw positioning. After harvesting 10 vertebral specimens (C3-C7) from intact (group A) and implanted spines (group B), implant stability was analyzed using a 4-point bending test comparing with groups A and C (reconstituted with plate and pins/polymethylmethacrylate after testing in Group A). RESULTS: All customized implants were applied without gross neurovascular damage. In addition, 90% of the screws were in a safe area, with 7.5% in grade 1 (< 1.3 mm) and 2.5% in grade 2 (> 1.3 mm). The mean entry point and angular deviations were 0.81 &#xb1; 0.43 mm and 6.50 &#xb1; 5.11&#xb0;, respectively. Groups B and C significantly decreased the range of motion (ROM) in C3-C7 compared with intact spines (= 0.033, and 0.018). Both groups reduced overall ROM and neutral zone in C4-C6, but only group B showed significance (= 0.005, and 0.027). CONCLUSION: Customized 3D-printed implants could safely and accurately replace a cervical vertebra in dog cadavers while providing primary stability.